[2024] Pass Cisco 350-801 Exam in First Attempt Easily
The Most Efficient 350-801 Pdf Dumps For Assured Success
NEW QUESTION # 183
Refer to the exhibit. What is a possible cause of the PRI issue?
- A. The clock source is incorrect.
- B. The framing is configured incorrectly.
- C. The controller shut down.
- D. The cable is unplugged.
Answer: B
Explanation:
https://www.cisco.com/c/en/us/support/docs/wan/t1-e1-t3-e3/8131-T1-pri.html
NEW QUESTION # 184
What are two key features of the Expressway series? (Choose two.)
- A. SIP header modification
- B. B2B calls
- C. VPN connect toward the internal UC resources
- D. Device registration over the internet
- E. IP to PSTN call connectivity
Answer: B,D
Explanation:
https://www.cisco.com/c/en/us/products/collateral/unified-communications/expressway- series/datasheet-c78-737605.html
NEW QUESTION # 185
AN engineer is implementing toll fraud prevention for incoming calls cluster-wide on cisco UCM. What is the first step to configure this feature?
- A. Configure blocking for inbound calls based on caller ID.
- B. Set service parameter "System Remote Access Blocked Numbers' to True
- C. Set service parameter 'Block OffNet to OffNet Transfer' to False
- D. Set service parameter 'Block OffNet To OffNet Transfer' to True
Answer: C
NEW QUESTION # 186
Drag and drop the SNMPv3 message types from the left onto the corresponding definitions on the right.
Answer:
Explanation:
NEW QUESTION # 187
An end used at a remote site is trying initiate an ad hoc conference call to an end user at the main site the conference bridge is configured to support G.711 remote user phone only support G.729 the remote end user receives an error message on the phone "cannot complete conference call what is the cause of the issue?
- A. A software conference bridge is not assigned
- B. A Media Termination Point is missing
- C. The transcoder resource is missing.
- D. The remote phone does not have the conference feature assigned.
Answer: C
NEW QUESTION # 188
Which call routing pattern is used for phone numbers that are in the E.164 format?
- A. /+.! Route Pattern
- B. \+.! Route pattern
- C. \+1. [2-9]XX[2-9]XXXXXXX called Party Transformation pattern
- D. \+.! Translation pattern
Answer: B
NEW QUESTION # 189
A company hosts a conference call with no local users How does the administrator stop the conference from continuing?
- A. modifies the Drop Ad Hoc Conference service parameter
- B. modifies the Block OffNet to OffNet Transfer service parameter
- C. changes the codecs that are supported on the conference resource
- D. removes the transcoder
Answer: A
NEW QUESTION # 190
An engineer must configure switch port 5/1 to send CDP packets to configure an attached Cisco IP phone to trust tagged traffic on it's access port.
Which command is required to complete the configuration?
- A. platform qos trust extend
- B. platform qos extend trust
- C. platform qos trust extend cos 3
- D. platform qos trust extend cos 5
Answer: A
NEW QUESTION # 191
Which Cisco UCM configuration is required for SIP MWI integrations?
- A. Enable "Accept presence subscription" on the SIP Trunk Security Profile.
- B. Select "Redirecting Diversion Header Delivery - Outbound" on the SIP trunk.
- C. Enable "Accept unsolicited notification" on the SIP Trunk Security Profile.
- D. Select "Redirecting Diversion Header Delivery - Inbound" on the SIP trunk.
Answer: C
Explanation:
In case of SIP integration, CUC sends SIP notify messages to the phone system to turn the MWI on or OFF so "Accept unsolicited notification" should be checked under SIP security profile assigned to the trunk.
https://community.cisco.com/t5/collaboration-voice-and-video/understanding-troubleshooting- mwi-on-unity-connection/ta-p/3162948
NEW QUESTION # 192
An engineer is configuring a phone system CISCO UCM and wants to activate TFTP service. The engineer selects the serviceability page for configuration. Which nodes configurable for TFTP?
- A. any node
- B. only nodes that have Cisco UCM service enabled
- C. any subscriber nodes
- D. any two nodes
Answer: B
Explanation:
TFTP is a network protocol that is used to transfer files between devices. It is often used to transfer firmware and configuration files to network devices. In order to use TFTP, the device must have a TFTP server configured.
In Cisco UCM, the TFTP server is configured on the serviceability page. The TFTP server can be configured on any node that has Cisco UCM service enabled. The TFTP server cannot be configured on nodes that do not have Cisco UCM service enabled.
NEW QUESTION # 193
Which two protocols should be configured for the cisco unity connection and cisco UCM integration?
- A. SCCP
- B. MGCP
- C. H.323
- D. RTP
- E. SIP
Answer: A,E
NEW QUESTION # 194
Which location must be assigned to the SIP trunk to replicate enhanced location information via a SIP trunk?
- A. phantom
- B. shadow
- C. hub_none
- D. replica
Answer: B
NEW QUESTION # 195
An administrator configures international calling on a Cisco UCM cluster and wants to minimize the number of route patterns that are needed. Which route pattern enables the administrator to match variable-length numbers?
- A. 9.011@
- B. 9.011*
- C. 9.011!
- D. 9.011#
Answer: B
NEW QUESTION # 196
A collaboration engineer must configure Cisco Unified Border Element to support up to five concurrent outbound calls across an Ethernet Link with a bandwidth of 160 kb to the Internet Telephony service provider.
Which set of commands allows the engineer to complete the task without compromising voice quality?
A)
B)
C)
D)
- A. Option C
- B. Option B
- C. Option D
- D. Option A
Answer: B
NEW QUESTION # 197
A company's employees have been complaining that they have been unable to select options on the internal IVR of the help desk IT support has been given Cisco UCM traces and below is the snippet of the SDP of the INVITE packet.
How is this issue resolved?
- A. Configure CODEC for G.729
- B. Configure DTMF for RFC 2833.
- C. Configure CODEC for G 722
- D. Configure DTMF for KPML
Answer: D
NEW QUESTION # 198
Refer to the exhibit. Which codec should an engineer select for a call mode between "Dallas- REG" & "Austin-REG"?
- A. MP4A-LATM
- B. G.729
- C. G.711
- D. OPUS
Answer: B
NEW QUESTION # 199
Refer to the exhibit. Which two codec permutations should be transcoded by this dspfarm? (Choose two.)
- A. iLBC to G.711ulaw
- B. G.722 to G.729r8
- C. G.729ar8 to G.711alaw
- D. G.729r8 to G.711ulaw
- E. G.728br8 to G.711alaw
Answer: C,D
NEW QUESTION # 200
Refer to the exhibit.
A call is failing to establish between two SIP Devices. The Called device answer with this SDP. Which SDP parameter causes this issue?
- A. The payload for G.711ulaw must be 18.
- B. The calling device did not offer a ptime value.
- C. The media stream is set to sendonly.
- D. The RTP port is set to 0.
Answer: D
NEW QUESTION # 201
An administrator is asked to implement toll fraud prevention in Cisco UCM, specifically to restrict off-net to off-net call transfers How is this implemented?
- A. Implement time-of-day routing.
- B. Set the appropriate service parameter
- C. Use the correct route filters.
- D. Enforce ad-hoc conference restrictions
Answer: B
NEW QUESTION # 202
On which Cisco Unified Communications Manager nodes can the TFTP service be enabled?
- A. Only nodes that have Cisco Unified CM service enabled
- B. Any node
- C. Any two nodes
- D. Any subscriber nodes
Answer: C
NEW QUESTION # 203
A network administrator deleted a user from the LDAP directory of a company. The end user shows as Inactive LDAP Synchronized User in Cisco Unified Communications Manager. Which step is next to remove this user from Cisco Unified Communications Manager?
- A. Execute a manual sync to refresh the local database and delete the end user.
- B. Wait 24 hours for the garbage collector to remove the user.
- C. Restart the Dirsync service after the user is deleted from LDAP directory.
- D. Delete the user directly from Cisco Unified Communications Manager
Answer: C
Explanation:
Section: Infrastructure and Design
NEW QUESTION # 204
Drag and drop the SNMPv3 message types from the left onto the corresponding definitions on the right.
Answer:
Explanation:
NEW QUESTION # 205
Refer to the exhibit.
Refer to the exhibit. An engineer configures a VoIP dial peer on a Cisco gateway. Which codec is used?
- A. No codec is used (missing codec command)
- B. G729r8
- C. G.711ulaw
- D. G711alaw
Answer: B
NEW QUESTION # 206
What dialled numbers match this Cisco UCM route pattern?
1[23]XX
- A. 1200 through 1399 only
- B. 1230 through 1239 only
- C. 12300 through 12399 only
- D. 1200 through 1300 only
Answer: A
NEW QUESTION # 207
What are two functions of a dial-plan? (Choose two.)
- A. ring cadence
- B. call recording
- C. endpoint features
- D. calling privileges
- E. digit manipulation
Answer: D,E
NEW QUESTION # 208
......
We offers you the latest free online 350-801 dumps to practice: https://pass4sure.verifieddumps.com/350-801-valid-exam-braindumps.html
