View All 300-610 Actual Exam Questions Answers and Explanations for Free Jan-2024
The Most In-Demand Cisco 300-610 Pass Guaranteed Quiz
NEW QUESTION # 93
Which two configurations allow for routing traffic between two VDCs? (Choose two.)
- A. Cross-connect the ports between the VDCs.
- B. Create VRF-aware software infrastructure interfaces.
- C. Connect the VDCs to an external Layer 3 device.
- D. Create interfaces in the VDC that can be accessed by another VDC.
- E. Create a policy map in the default VDC that routes traffic between the VDCs.
Answer: A,C
Explanation:
The Cisco NX-OS software does not support direct communication between VDCs on a single physical device. You must make a physical connection from a port allocated to one VDC to a port allocated to the other VDC to allow the VDCs to communicate.
NEW QUESTION # 94
Drag and drop the configurations from the left onto the correct policies on the right.
Answer:
Explanation:
NEW QUESTION # 95
An engineer must design a Cisco UCS environment for a customer The design requires the most efficient use of available bandwidth with active-active uplinks The upstream Cisco Nexus 9000 Series Switch must automatically initiate the port-channel connectivity to the fabric interconnects Which configuration must the engineer choose to meet these requirements?
- A. * fabric interconnects in Ethernet switching mode
* static port-channel from fabric interconnects and Cisco Nexus 9000 switches - B. * fabric interconnects in Ethernet end-host mode
* static port-channel from fabric interconnects and Cisco Nexus 9000 switches - C. * fabric interconnects in Ethernet end-host mode
* LACP port-channel from fabric interconnects and Cisco Nexus 9000 switches - D. * fabric interconnects in Ethernet switching mode
* LACP port-channel from fabric interconnects and Cisco Nexus 9000 switches
Answer: C
Explanation:
Reference:
Cisco UCS Fabric Interconnect in Switch Mode with Cisco MDS 9000 Family Fibre Channel Switching Modules When the Cisco UCS Fabric Interconnect is in switch mode, the port channel mode can only be in ON mode and not Active . However, to get the peer wwn information for the Fabric Interconnect, the port channel must be in Active mode.
NEW QUESTION # 96
Refer to the exhibit.
A cloud provider service provider deployed three geographically separated Cisco ACI data centers. One of the customers needs to host a clustered application that is spread across the three data centers. The cluster nodes that host the application need a layer 2 topology to communicate with each other. Which Cisco ACI topology design meets these requirements?
- A. Multi-cloud
- B. Multi-pod over MP-BGP EVPN
- C. Multi-pod over OSPF EVPN
- D. Multi-site
Answer: D
Explanation:
Each data center has its own APIC cluster. This is multi-site setup.
NEW QUESTION # 97
An engineer must provide Layer 2 adjacency between data centers that are in two locations and separated by a routed network The adjacency must be based on Cisco Nexus 7000 Series Switches The solution must offload learning of host reachability information to the control plane to avoid excessive flood and learn congestion Also the data center in one of the sites experiences a large volume of unknown unicast traffic that the solution must mitigate Which data center interconnect technology meets these requirements?
- A. VXLAN
- B. OTV
- C. LISP
- D. VPLS
Answer: A
NEW QUESTION # 98
A failure occurs on the network between two BFD and OSPF neighbors. Drag and drop the protocol actions from the left into the correct order on the right.
Answer:
Explanation:
NEW QUESTION # 99
Drag the requirements from the left onto the correct policy types on the right.
Answer:
Explanation:
NEW QUESTION # 100
What are two advantages of using Cisco vPC over traditional access layer designs? (Choose two.)
- A. no spanning-tree blocked ports
- B. maintains single control plane
- C. uses all available uplink bandwidth
- D. disables spanning-tree
- E. supports Layer 3 port channels
Answer: A,C
Explanation:
Section: Network Design
Explanation/Reference: https://www.cisco.com/c/dam/en/us/td/docs/switches/datacenter/sw/design/vpc_design/ vpc_best_practices_design_guide.pdf
NEW QUESTION # 101
Drag and drop the feature descriptions from the left onto the correct UCS Fabric Interconnect modes on the right.
Answer:
Explanation:
NEW QUESTION # 102
Refer to the exhibit.
A cloud service provider deployed three geographically separated Cisco ACI data centers. One of the customers needs to host a clustered application that is spread across the three data centers. The cluster nodes that host the application need a Layer 2 topology to communicate with each other.
Which Cisco ACI topology design meets these requirements?
- A. Multi-Site
- B. Multi-Pod over OSPF EVPN
- C. Multi-Pod over MP-BGP EVPN
- D. Multi-Cloud
Answer: C
NEW QUESTION # 103
A network architect designs a high-availability architecture for the Cisco UCS Fabric interconnects that installed in a data center. The architecture must support clustering and redundancy. Which architecture meets these requirements?
- A. dual connections from port L1 to L1and one connection from port L1 to L1 with twinax cables
- B. dual connections from port L1 to 12 and one connection from port L2 to L1 with twinax cables
- C. dual connections from port L1 to L2 and one connection from port L2 to L1 with Ethernet cables dual
- D. dual connections from port L1 to L1 and one connection from port L2 to L2 with Ethernet cables
Answer: D
Explanation:
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/sw/gui/config/guide/1-0-2/b_GUI_Config_Guide/GUI_Config_Guide_chapter4.pdf
NEW QUESTION # 104
Which orchestration tool provides a graphical interface to manage LAN and SAN fabrics?
- A. Cisco CloudCenter
- B. Cisco Data Center Network Manager
- C. Cisco Virtual Topology System
- D. Cisco Nexus Fabric Manager
Answer: C
NEW QUESTION # 105
An engineer configured the OSPF protocol in the vPC topology. During the catastrophic failure of one of the vPC the member switches, the traffic was routed to a black hole. This route was caused by the long convergence time caused by the delay of the of the vPC member switch reboot. After the failure, the engineer rebooted both switches, but the secondary switch powered on before the primary one. It caused all the vPCs to be shut down due to consistency-check violations. Which two features must be used to prevent these situations from happening in the future? (Choose two.)
- A. ip arp synchronize
- B. peer-gateway
- C. system priority
- D. auto-recovery
- E. delay restore
Answer: D,E
Explanation:
System priority is related to LACP, not vPC, so it is out. ARP s
https://www.cisco.com/c/en/us/support/docs/switches/nexus-7000-series-switches/116187-configure-vpc-00.html
https://www.cisco.com/c/en/us/support/docs/ios-nx-os-software/nx-os-software/212589-understanding-vpc-election-process.html
NEW QUESTION # 106
Drag and drop the technologies from the left onto the correct descriptions on the right.
Answer:
Explanation:
NEW QUESTION # 107
A failure occurs on the network between two BFD and OSPF neighbors. Drag and drop the protocol actions from the left into the correct order on the right.
Answer:
Explanation:
NEW QUESTION # 108
An engineer must design a solution to divide the workload across two different data centers and achieve redundancy in case of the failure of either data center Which solution must the engineer choose?
- A. Cisco Hyperflex edge cluster
- B. single Cisco HyperFlex stretched cluster
- C. Cisco Hyperflex ROBO cluster
- D. single Cisco HyperFlex standard cluster
Answer: B
NEW QUESTION # 109
Which two methods mitigate congestion in a SAN network? (Choose two.)
- A. Use the port-monitor command to detect slow drain devices.
- B. Configure ER_RDY to allow splitting of each ISL between switches into separate virtual links.
- C. Configure the port monitor to allow categorization of a specific device as slow.
- D. Configure the flow control for the FC to use R_RDY.
- E. Configure the port channel to enable individual buffer-to-buffer credits.
Answer: A,C
NEW QUESTION # 110
Drag and drop the data center technologies from the left onto the correct descriptions on the right. Not all technologies are used.
Answer:
Explanation:
NEW QUESTION # 111
Refer to the exhibit.
The FCoE packets fail to be forwarded through the switch. What is the minimum MTU QoS requirement for the FCoE to work?
- A. 2158 bytes
- B. 9000 bytes
- C. 2240 bytes
- D. 2000 bytes
Answer: D
Explanation:
Section: Storage Network Design
NEW QUESTION # 112
Drag the appropriate from the left onto the current UDLD modes of operation on the right.
Answer:
Explanation:
NEW QUESTION # 113
A network architect designs the iSCSI-based storage area network solution. The iSCSI datastore must be designed with high availability, minimal downtime, and no single point of failure. The requirement is to fail over I/O to alternate paths based on SCSI sense codes without reliance on network failures.
Which feature must be deployed to meet these requirements?
- A. NIC teaming
- B. iSCSI multipath
- C. hardware-based flow control
- D. port security
Answer: B
NEW QUESTION # 114
Which two features are provided by deploying an OOB management network in a Cisco Nexus data center? (Choose two.)
- A. Layer 3 path for server traffic
- B. Layer 2 path for a vPC peer link
- C. Layer 3 path for vPC keepalive packets
- D. Layer 3 path for monitoring purposes
- E. Layer 2 path for server traffic
Answer: B,E
NEW QUESTION # 115
Drag the appropriate from the left onto the current UDLD modes of operation on the right.
Answer:
Explanation:
NEW QUESTION # 116
A network engineer is implementing Cisco UCS manager with Cisco UCS center integration. The company is strict security policies require that the logical profile of virtual network adapters and logical addressing assigned to Cisco UCS servers be managed by the Cisco UCS manager. The users must also be prevented from being able to acknowledge pending activities in the Cisco UCS manager. Which two profile must be used to meet these requirements? (Choose two.)
- A. Public network control
- B. Local service
- C. Local power
- D. Global maintenance
- E. Restricted chassis
Answer: B,D
Explanation:
https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-central/GUI-User-Guides/Operations/b_UCSC_Ops_Guide/b_UCSC_Ops_Guide_chapter_0111.html#id_16185
NEW QUESTION # 117
......
300-610 Free Certification Exam Material with 206 Q&As : https://pass4sure.verifieddumps.com/300-610-valid-exam-braindumps.html
